This LV Automotive 160pcs cable clamp kit gives you eight clamp diameters from 6 mm up to 32 mm so you can tie down most wiring or hose runs in one go. Each clamp shares a 15 mm band width and 6.4 mm mounting hole so the whole setup matches standard M6 hardware across trailers, canopies and engine bays. The hard case keeps each size in its own compartment so you can grab the right clamp without rummaging. Each clamp runs a mild steel band with an EPDM rubber insert so the cable sits snug and protected against vibration and panel edges. The steel ends are reinforced around the 6.4 mm mounting eye so they sit flat under normal bolt torque. The 160 piece count covers small gauge wiring at 6 mm right through to chunkier looms or hoses at 32 mm, which is a smart buy for any shed or mobile toolkit.

• 160-piece LV Automotive cable clamp assortment kit
• Clamp internal diameters from 6 mm to 32 mm
• Consistent 15 mm wide mild steel band construction
• EPDM rubber liner protects and grips cable insulation
• 6.4 mm mounting hole suitable for standard M6 hardware
• Includes eight clamp sizes for mixed wiring and hose runs
• Reinforced band ends for secure fastening to panels or rails
• Supplied in plastic compartment organiser case for storage
• Suitable for automotive, trailer and marine wiring layouts
• Ideal for securing cable looms along chassis rails and frames

Q: What hardware size suits the 6.4 mm clamp holes?

The 6.4 mm holes suit standard M6 bolts or screws. Most automotive and marine brackets, chassis rails and panels already use M6 hardware so you can tie into existing points. Using the same size fastener across the kit keeps installs straightforward. Just match the bolt length to the bracket thickness and clamp stack.

Q: Can these clamps be used on small hoses as well as cables?

Yes, the mild steel band and EPDM rubber liner work with both cables and light hoses. The size range from 6 mm to 32 mm covers many breather lines and small coolant or fuel hoses. Make sure the hose outer diameter matches the clamp size for firm support. Avoid overtightening so the hose is held without flattening.

Q: Are the clamp sizes marked or separated in the box?

The plastic organiser case separates each size into its own compartment. The layout groups similar diameters together for quick picking at the bench or on the trailer drawbar. You can label the lid if you want quicker identification. Keeping them sorted helps track remaining quantities.

Q: Is this kit suitable to keep in a vehicle or boat full-time?

Yes, the clamps are supplied in a hard plastic case suited to storage in a ute canopy or cabin locker. The compartments help stop pieces shifting around on corrugated tracks or choppy water. Keeping a 160 piece kit on board means you can tidy loose wiring as you add accessories. Just keep the lid latched between jobs.