This LV Automotive 12V 5 Pin Waterproof Relay C/O with base gives you a tidy way to switch 12V gear from lights to compressors on the same run. The 5 pin changeover layout means you can swap between two outputs on one input in a standard automotive circuit. The sealed housing keeps spray and grime off the contacts when you get out there on wet tracks. The relay uses an Aptiv waterproof body with 5 plated terminals sitting inside a solid plastic case. The matching base takes those 5 pins and locks them in with proper seals around each wire. The terminals are shaped for common 12V automotive cable so you can build a neat harness as part of a smart buy wiring setup. The kit comes with seals and a removal tool so you can service the connection later without drama.

• 12V DC automotive relay for accessory circuits
• 5 pin changeover configuration for flexible wiring
• Waterproof Aptiv relay body for exposed locations
• Supplied with matching relay base housing
• Includes 5 crimp terminals for the base
• Includes wire seals to protect each terminal
• Includes terminal position insert and removal tool
• Suits typical 12V vehicle and 4x4 setups
• Helps keep wiring neat and serviceable
• LV Automotive branded electrical gear

Q: Is this relay suitable for mounting in the engine bay?

Yes, the relay uses a sealed waterproof housing suited to exposed engine bay locations. The body and base are designed to keep moisture and grime away from the contacts. Good mounting spots include near the battery or fuse area. Just make sure wiring is supported and fused correctly in your setup.

Q: Does the kit include the terminals for the relay base?

Yes, the kit includes terminals that match the relay base. These terminals crimp onto your 12V wiring and then lock into the base. The supplied seals fit over each wire before insertion. That combination helps keep the connection tight and protected over time.

Q: Can I use this relay for switching auxiliary driving lights?

Yes, this style of 12V 5 pin changeover relay is commonly used for auxiliary lighting circuits. You run the light power feed through the relay contacts and control the coil with a switch circuit. Always size your cable and fuse to suit the light load and follow basic auto-electrical practices.

Q: What is the advantage of the changeover (C/O) function?

The changeover function gives you a common input that can switch between two outputs. That setup is handy when you want one circuit live when the relay is off and another live when it is on. Many users apply this for logic control or to swap power between accessories. It offers more flexibility than a simple on off relay.