This LV Automotive 12 mm cable clamp kit keeps wiring and small hose runs tied down along panels, chassis rails and engine bays, using a 15 mm wide band and 6.4 mm mounting hole. Each clamp wraps snug around 12 mm outer diameter gear so you can tackle long accessory installs without loose cables slapping metal. The temperature rating from -35°C to 100°C suits work utes, touring rigs and trailers in real Aussie heat.

The band is grade W3 stainless steel, giving solid corrosion resistance when you get out there through coastal air or muddy creek crossings. An EPDM rubber liner sits between the 12 mm cable and steel band so the jacket holds up weekend after weekend. Softened edges and reinforced tips help the clamp keep shape when bolts bite through the 6.4 mm holes. A ten pack offers smart buy value for complete rewires or new fitouts.

• Suits cables or hoses with 12 mm outside diameter
• 15 mm wide band supports each clamp point
• 6.4 mm mounting hole matches common M6 fasteners
• Grade W3 stainless steel resists corrosion
• EPDM rubber liner cushions and grips cable
• Softened band edges reduce abrasion risk
• Reinforced band tips maintain shape under load
• Operating temperature range from -35°C to 100°C
• Pack contains 10 individual cable clamps
• Ideal for securing wiring in automotive and trailer setups

Q: Can these clamps be used in marine or coastal environments?

Yes, the clamps use grade W3 stainless steel which offers corrosion resistance. This material handles salt spray around boat trailers and coastal utes better than mild steel. The EPDM rubber liner also holds up against moisture. Rinsing with fresh water after heavy salt exposure will still help extend service life.

Q: What size cable or hose actually fits these clamps?

These clamps suit lines with an outside diameter of approximately 12 mm. That size covers many common auto power and accessory cables as well as small hoses. Measuring the outer diameter of your cable before ordering will confirm compatibility. Oversized cables may stress the band or reduce rubber contact.

Q: What type of fastener should I use with the 6.4 mm hole?

Any suitable screw or bolt with a shank under 6.4 mm can be used. Many users choose M6 bolts or similar self-tapping screws depending on the mounting surface. The final choice should match the material thickness and load. Stainless fasteners will best match the clamp for corrosion resistance.

Q: Are these clamps suitable near high-temperature engine components?

They are suitable within their -35°C to 100°C temperature rating. This range covers most engine bay and under-bonnet locations away from direct exhaust heat. Mounting too close to manifolds or turbo housings can exceed 100°C and shorten EPDM life. Placing clamps on cooler panels or rails will keep the liner performing longer.

• Suits cables or hoses with 12 mm outside diameter
• Mounts using a 6.4 mm fastener through the clamp hole
• Suitable for routing electrical wiring in automotive and marine setups within -35°C to 100°C
• EPDM rubber liner supports cable grip on metal mounting surfaces