This LV Automotive 120A grey power connector kit suits anyone running high draw 12V gear that pulls up to 120A through 6 B&S cable at 14 mm². The grey Anderson-style body mates with other grey 120A connectors so you can hook up trailers, fridges or chargers without hunting for matching male or female plugs. The setup works well on canopies, camper trailers and tow rigs that cop plenty of corrugations. The housing uses tough grey plastic with a footprint that lines up with standard Anderson mounting plates and brackets. The contacts are sized for 6 B&S 14 mm² cable so you get a solid crimp and full current capacity instead of a choked-down link. The genderless layout keeps wiring straightforward when you are building extension leads or battery jump leads. For Aussie conditions and long trips, it is a smart buy as a spare or as part of a new 12V build.

• 120A grey genderless Anderson-style power connector pair
• Suits 6 B&S (14 mm²) low-voltage cable
• Ideal for high current 12V and 24V DC circuits
• Commonly used on 4WD, caravan and trailer power links
• Grey housing matches standard 120A Anderson setups
• Genderless design allows any two housings to mate
• Twin bolt holes for secure fixed mounting points
• Heavy duty construction suited to frequent connect and disconnect
• Supports low-resistance power transfer on long accessory runs
• LV Automotive brand connector in heavy duty category

Q: Can I use smaller cable than 6 B&S with this 120A grey connector?

It is intended for 6 B&S (14 mm²) cable. You can physically crimp smaller conductors with the right lugs, but you lose the current capacity that matches the 120A rating. Most touring and trailer builds stick with 6 B&S for long runs. Keeping cable size matched to the connector spec avoids hot spots and voltage drop.

Q: Are these grey 120A power connectors suitable for both 12V and 24V systems?

Yes, they suit low-voltage DC systems such as 12V and 24V. The important factor is the current draw staying within the 120A rating. Many 4WD and truck setups use the same style connector across both voltages. Just keep polarity consistent and cable sized correctly. The grey colour helps you standardise one circuit type across your gear.

Q: Do these LV Automotive connectors mate with other grey Anderson-style plugs already on my trailer?

They are described as genderless Anderson type, so they are intended to mate with matching grey Anderson-style connectors of the same 120A size. In practice most grey 120A housings share compatible dimensions. Always confirm by checking fit before final crimping and mounting. Once matched, you can swap trailers or accessories without extra adapters.

Q: Where would I normally mount a 120A grey connector using this pair?

Common spots include rear bumpers, tow bars, drawbars, and canopy power boards. The twin bolt holes in each housing let you screw the connector to brackets or flat panels. Keeping the plug near the hitch keeps Anderson leads short and tidy. Mounting out of direct stone spray and using 6 B&S 14 mm² cable helps the connection last longer on corrugated roads.

• Suits cable size 6 B&S (14 mm²) only

• For low-voltage DC power setups that require 120A Anderson-style connectors

• Commonly used to link batteries, chargers or power distribution in 4WD, caravan and trailer wiring

• Genderless design allows either connector half to mate with another of the same style