This TAG Pulse Complete 7 Pin Flat Socket Wiring Kit gives your towbar a standard 7 pin flat socket and a 1.5 m cable run so you can hook up trailers that use basic 12V light circuits. The layout matches common Aussie trailer wiring so your brake, tail and indicator lines all land on the right pins. You get a universal harness that suits different vehicles with towbar mounts positioned within 1.5 m of a splice point.

The kit runs insulated cable over the full 1.5 m length and a moulded plastic socket body that bolts to typical towbar plates under about 50 mm high. The 7 pin flat socket matches standard Australian trailer plugs with seven clearly defined terminals. There is no diagnostic coding listed and no fog or reverse sensor cut-off listed so the wiring stays straightforward. For basic towing setups this is a smart buy that keeps the electrics tidy.

• Universal wiring kit for towbar applications

• Includes 7 pin flat trailer socket

• Supplied with pre-attached 1.5 m cable

• Suits standard Australian 12V trailer wiring

• Approximate fitting time of 2 hours

• No diagnostic coding required on installation

• Fog light cut-off not applicable for this kit

• Reverse sensor cut-off not applicable

• Suits vehicles without factory trailer wiring harness

• Moulded socket housing with metal fasteners

Q: Is this TAG wiring kit suitable for most trailers using a 7 pin flat plug?

Yes, it is made for standard 7 pin flat trailer plugs. The pin layout follows common Australian wiring for brake, tail, indicator and auxiliary circuits. That means most box trailers, campers and small vans that use a 7 pin flat plug will match. Always double-check your trailer wiring colours to confirm before final connection.

Q: How long is the cable supplied with this wiring kit?

The cable length is 1.5 m. This length suits many towbar installs where the junction point or splice is close to the rear of the vehicle. If your mounting point is further away you may need to extend the wiring using suitable automotive cable. Keeping joins protected and supported will help the kit last longer.

Q: Does this kit require any diagnostic coding or integration with vehicle electronics?

No, diagnostic coding is listed as not applicable for this kit. The harness is a straightforward universal style that taps into existing lighting circuits. That suits many older vehicles or basic electrical setups. Always isolate the battery and follow standard automotive wiring practices. If unsure, get an auto electrician to complete the final connections.

Q: Can this wiring kit cut off reverse sensors or fog lights when towing?

No, reverse sensor cut-off and fog cut-off are both listed as not applicable. The kit focuses on providing power to the trailer lights only. If your vehicle uses rear sensors or advanced lighting control, those systems will keep working as normal. For complex setups you may need additional modules supplied separately by your vehicle or towbar specialist.

• Fitment type: Universal wiring kit for trailer and towbar applications

• Plug style: 7 pin flat socket for standard trailer wiring

• Approximate fitting time: 2 hours

• Diagnostic coding: Not required

• Fog light cut-off integration: Not applicable

• Reverse parking sensor cut-off integration: Not applicable