The Hulk 4x4 Single Surface Mount Housing is a small bit of gear that keeps one socket in the right spot with a hole size of 29 mm. The footprint sits at 55 mm by 50 mm, so it suits tight dash corners or overhead panels. With a 41 mm centre-to-centre mount, you can line up two screws and know the housing will stay put when the track gets rough.

The moulded housing covers the back of the socket across its full 29 mm opening, adding support where the panel is weakest. The 55 mm length and 50 mm width spread the load so thin sheet or cabinetry handles constant vibration better. Those 41 mm fixing points make it a smart buy for standard panels in campers and 4x4 setups that need gear mounted once and left alone.

• Hulk 4x4 single surface mount housing
• Suits one accessory socket only
• Overall footprint measures 55mm x 50mm
• Socket mounting hole size is 29mm
• Fixing hole centres spaced at 41mm
• Compact design for tight dash areas
• Surface mount style for flat panels
• Helps support and protect socket body
• Matches common 12V and USB socket sizes
• Supplied as housing only without socket

Q: What size socket will fit this Hulk 4x4 Single Surface Mount Housing?

It suits a socket body that needs a 29 mm mounting hole. That means most standard 12V accessory or USB sockets built for a 29 mm panel cut-out will drop straight in. Always check your socket spec before cutting the panel. A correct fit in the 29 mm bore helps stop rattles on corrugations.

Q: How much flat space do I need on the panel to mount this housing?

You need at least 55 mm by 50 mm of flat area. That covers the full footprint of the housing so the base sits flush. Allow a little extra room for tools when drilling the 41 mm centre-to-centre fixing holes. Making sure the panel is flat helps the housing clamp down evenly.

Q: Can I add this housing to thin cabinetry in a camper or caravan?

Yes, as long as the panel can take the two fasteners at 41 mm centres. Thin ply or sheet often benefits from using suitable washers or backing where space allows. The 55 mm by 50 mm base helps spread the load out. That can reduce flex around the 29 mm socket opening over time.

Q: Is this housing supplied with the socket already installed?

No, this listing is for the housing only. You choose a compatible socket that suits your wiring setup and needs a 29 mm cut-out. This lets you match the housing with 12V, USB or other accessory modules. It also keeps replacement simple if the electrical part ever needs swapping out.