Grab the KT Accessories Adhesive Heat Shrink Medium Wall 110mm when you want big cables covered properly on the ute or camper. The wide bore suits chunky battery leads and multi-core looms up to 110mm before you hit it with the heat gun, so those joins near the drawbar or chassis stay tucked away from rocks and grime across 100 km corrugated tracks.

This sleeve uses a medium wall polyolefin tube with adhesive lining that flows once you reach around 120°C, locking tight around the insulation for a solid seal. The black finish sits well on exposed chassis rails in temps over 30°C, common on Aussie summer runs. You get straightforward cable protection for 12V and 24V setups in 4WDs, boats and trailers, which makes it a smart buy for any touring kit.

• Adhesive-lined heat shrink for secure sealing
• Medium wall construction for added durability
• Large 110mm diameter suits big cable looms
• Black polyolefin tube for cable protection
• Ideal for 12V and 24V wiring layouts
• Suits trailers, campers, 4WDs and marine setups
• Provides abrasion resistance on exposed wiring runs
• Helps keep dust and moisture away from joins
• Works with standard electric heat guns
• KT Accessories branded electrical protection gear

Q: What diameter cable bundles will this 110mm adhesive heat shrink suit?

This heat shrink suits cable bundles and junctions up to approximately 110mm outside diameter before shrinking. You slide the tube over the largest section of the loom while it is still at full size. Once positioned, you apply heat so the tube contracts down around the insulation. Always confirm your cable bundle is smaller than the stated 110mm to allow for easy installation.

Q: Is this medium wall adhesive heat shrink suitable for trailer wiring repairs?

Yes, the medium wall 110mm adhesive heat shrink is well suited to trailer wiring repairs and modifications. The thicker wall helps shield joins from stone spray and road grime under the chassis. The adhesive lining flows under heat to fill gaps around uneven insulation. That makes it useful for sealing older looms where the outer jacket is worn or slightly misshapen.

Q: Can I use this heat shrink on both 12V and 24V electrical setups?

Yes, this adhesive heat shrink is suitable for both 12V and 24V electrical setups. The tubing provides mechanical protection and environmental sealing rather than electrical insulation alone. That means it works across typical low-voltage automotive and marine wiring. You just need to match the 110mm size and medium wall spec to the physical cable bundle you are covering.

Q: What tool should I use to shrink this 110mm medium wall tubing?

A standard electric heat gun is the most suitable tool for shrinking this 110mm medium wall tubing. A heat gun gives controlled, even heat so the adhesive lining melts and flows consistently around the cables. You move the heat source along the length of the tube to avoid scorching any one area. Open flame is not recommended because it can mark insulation or overheat the polyolefin material.