The RWB Marine drink holder with suction base keeps cans, cups and small bottles up to 65 mm diameter parked where you want them on the boat. The suction pad sticks to smooth gelcoat, stainless benches or cabin tables so you can shift your setup as the crew moves. The tall straight sides cradle a standard can so it stays put when the wake from a 6 m tinny rolls through.

The holder is moulded from white PVC, so it shrugs off spray and the odd knock against a rod butt. The wide ribbed base spreads the suction load across a decent patch of deck, giving the kit a solid feel without screws. The blue nautical logo on the side ties in neatly with most marine trims. If you want simple drink storage that works in real Aussie boating conditions, this is a smart buy.

• White PVC suction drink holder
• Suits marine decks and cockpits
• Holds cans cups and small bottles
• Fits containers up to 65 mm diameter
• Suction grip base for repositioning
• Printed blue nautical logo on side
• No drilling or screws required
• Lightweight accessory for small boats
• Works on smooth non-porous surfaces
• Part number RWB1040 from RWB Marine

Q: Will this suction drink holder stick to textured or non-smooth surfaces?

This holder works best on smooth, non-porous surfaces. Textured or heavily curved panels reduce suction grip and can let air under the base. For the strongest hold, use it on clean gelcoat, glass, or polished metal. Wipe away salt and grit before pressing the suction base down.

Q: What size drink containers will fit this holder?

It accepts containers up to 65 mm diameter. That covers standard soft drink cans and many small plastic bottles. Wider insulated mugs or large bottles may not sit fully in the cup. If the container is under the 65 mm limit it will sit more securely in chop.

Q: Can I leave the PVC drink holder outside permanently?

PVC handles typical marine exposure but still benefits from basic care. Long-term sun and salt will slowly age any plastic. Rinse the holder with fresh water after trips and stow it when the boat is not in use. This simple routine keeps the PVC looking cleaner for longer.

Q: Does the holder require any drilling or permanent fixings?

No drilling is required because it uses a suction base. This suits boats where you want to avoid extra screw holes in gelcoat or trim. You can shift the holder between cockpit, cabin, and swim platform as needed. Just release the suction and move it to a new clean spot.

Suitable for use on smooth non-porous surfaces on boats or marine setups where a suction base can adhere. The suction grip allows repositioning of the holder wherever required. Fits drink containers up to 65 mm diameter including standard cans and small bottles.