The Camec 12 Volt Solar Panel Cable Kit 2 Piece lets you hook two folding solar panels into one 12 volt setup so you can get out there with a bit more charge going back into the batteries. You get a 3 metre positive and negative lead plus a matching splitter so both panels feed into the same camping regulator without dragging a tangle of short cables across the site.

The connectors are sized for 12 volt solar gear and the 3 metre length gives enough reach to park panels out in the sun while the caravan or canopy sits in the shade. The splitter keeps the positive and negative runs tidy so you can trace the line at a glance when you are packing up or fault finding. For anyone running portable folding panels this is a smart buy that keeps the setup simple.

• 12 Volt solar connector cable kit
• Includes 3 metre positive/negative lead
• Includes matching positive/negative splitter
• Links two folding solar panels together
• Suits caravan, RV and camping solar setups
• Helps position panels further from regulator
• Keeps wiring polarity matched and simple
• Two piece kit for tidy portable layouts
• Compatible with 12V low voltage DC systems
• Classified as solar connector accessory

Q: Can this cable kit be used with any 12V folding solar panel?

It can be used with 12V folding solar panels that share the same style of solar connectors and similar current ratings. The kit is intended for low voltage DC camping and RV systems, so it suits most portable folding panels sold for that purpose. Always match connector type before purchase. If the plugs differ, an adapter lead will be required.

Q: Does the 3 metre lead run from the panels to the regulator?

Yes, the 3 metre positive and negative lead is intended to run between the combined panels and the regulator or charge input. The length gives flexibility to place panels away from the vehicle while still reaching the power system. Keeping this run to 3 metres also helps limit voltage drop in typical portable setups. Coiling unused length is simple during shorter runs.

Q: Can this kit increase the charging current to my battery?

It can allow higher charging current when you connect a second compatible panel in parallel, within the limits of your regulator. The splitter lets two panels feed one charge controller, so total wattage increases compared to a single panel. Your regulator must be rated to handle the combined current. Always check panel and regulator specifications before upgrading.

Q: Is this cable kit suitable for permanent roof-mounted panels?

It is mainly suited to portable folding panels rather than hard-mounted roof arrays. The 3 metre length and plug style are set up for temporary campsite layouts where panels are moved and stored often. Roof systems usually use longer fixed cabling and different mounting hardware. For permanent installations, dedicated rooftop cabling and fittings are recommended.

Suitable for 12 Volt solar setups that use folding solar panels and compatible connectors. Kit connects two folding solar panels in parallel via the positive and negative splitter. Intended for use between panels and existing solar regulators or controllers in caravan, RV or camping power systems.