This Viking 8" Alloy HT Holden Integral Wheel & Tyre kit gives your boat trailer an 8" rolling setup that suits tight ramps and short to mid range tows. The HT Holden pattern lines up with common marine hubs so you can swap out a tired wheel for a matched alloy and tyre combo. The LM marine bearing kit with seal and dust cap means the hub can be refreshed at the same time. The alloy wheel handles regular dunking at salty ramps better than bare steel thanks to its corrosion resistant material. The integral design keeps the 8" rim and centre as one piece for straightforward balancing and fitment. The LM marine bearings are standard trailer size so spares stay simple out on the road. Put it together right once and this wheel and bearing kit is a smart buy for Aussie coastal towing.

• 8" alloy HT Holden integral wheel and tyre assembly
• Marine application suited to small boat trailers
• Integral alloy wheel resists typical marine corrosion
• HT Holden pattern fits compatible marine trailer hubs
• LM marine wheel bearing kit included in the pack
• Bearings supplied with matching seal and dust cap
• Single brand Viking assembly for consistent quality
• Compact 8" diameter helps keep trailer ride height low
• Ideal for replacing worn wheel, tyre and bearings in one go
• Suits buyers wanting simple marine trailer wheel maintenance

Q: Is this wheel and tyre suitable for use on boat trailers that enter salt water regularly?

Yes, this assembly is intended for marine trailer use. The alloy wheel construction copes better with repeated salt exposure than untreated steel wheels. Regular rinsing with fresh water after each launch still matters to slow corrosion. The included LM marine bearings also suit hubs typically found on small boat trailers.

Q: What bearing type is included with this kit?

The kit includes an LM marine wheel bearing set. LM bearings are a common size on light marine and box trailers. Having the correct LM bearing, matching seal and dust cap in the box keeps the hub service straightforward. It also avoids mix and match parts that can shorten bearing life.

Q: Do I need any extra parts to mount this wheel and tyre assembly?

You will need suitable wheel nuts or studs that match your existing HT Holden hubs. The kit supplies the wheel, tyre, LM bearings, seal and dust cap only. Correct mounting hardware should already be on your trailer hub. Always check thread size and condition before tensioning the wheel to spec.

Q: Can this 8" assembly replace a larger trailer wheel size?

It should only replace an existing 8 inch wheel and tyre specified for the trailer. Swapping from a larger diameter to an 8 inch setup can change ride height and load rating. Always confirm the trailer compliance plate and original wheel size. Matching the factory size keeps braking, clearance and legal load figures correct.

Gear suits marine trailers built to HT Holden wheel pattern that run LM marine wheel bearings.

Setup is intended for boat trailers where an 8 inch wheel and tyre assembly is specified.

Kit supplies the LM marine wheel bearing kit required for hubs that accept LM bearing sets.

Users should confirm stud pattern, hub style and load rating on their existing trailer before fitment.

Installation should follow normal marine trailer wheel and bearing service procedures used by a qualified person.