If you are running a serious 12 V setup pulling close to 110 A, this Tycab 16mm² Marine Battery Cable with its black sheath is solid gear for the job. The 16 mm² core and 224 strands at 0.2 mm keep voltage drop in check over practical runs under 5 m. You buy it per 1 m, so you can cut in the shed and land neat lengths from battery to isolator or from start battery to winch.

The cable lines up with standard 6 B&S lugs, so crimping into existing 12 V or 24 V systems is straightforward with the right tools. The black sheath adds a tough outer layer around about 2 mm thick, giving extra protection across chassis rails and bulkheads. With a continuous current rating of 110 A, it is a smart buy for Aussies wiring battery banks, chargers or inverters that need dependable cable in hot engine bays.

• Tycab 16mm² marine battery cable
• Rated to carry up to 110A
• 224 fine strands of 0.2mm conductor
• Flexible construction suits tight routing
• Durable black outer sheath for protection
• Compatible with common 6 B&S lugs
• Suitable for 12V and 24V battery systems
• Sold per metre for precise cable lengths
• Ideal for high-draw chargers, inverters and winches
• Black colour assists with circuit identification

Q: Can this 16mm² cable be used in both 12V and 24V systems?

Yes, this 16mm² marine battery cable is suitable for 12V and 24V systems. The key limit is the continuous current rating of 110A, not the nominal system voltage. In practice that covers many starter motors, DC-DC chargers and inverters within that current range. Always size cable to both current and run length to control voltage drop.

Q: What lugs or terminals match this 16mm² marine cable?

This cable matches standard 6 B&S or 16mm² cable lugs and terminals. Using the correct size lug gives a full-contact crimp and keeps resistance low at high current. Undersized lugs can damage strands and raise temperatures at the joint. Use a suitable hex or indent crimper rated for 16mm² conductors.

Q: How is this Tycab cable supplied when ordered online?

The cable is sold and supplied per metre as a continuous length. If you order 5 units you receive one 5m length, not five separate 1m pieces. That makes it easier to plan long runs from battery to distribution points. You can then cut to size on the bench before installation.

Q: Is this cable flexible enough for tight bends around battery boxes?

Yes, the conductor uses 224 strands of 0.2mm wire, which improves flexibility compared with coarse-strand cable. This fine stranding helps you route the cable around corners and through conduits without sharp kinks. It also reduces stress on the conductor when the cable moves slightly in service. Still avoid bends tighter than the manufacturer’s typical minimum radius guidelines.