This AFN bullbar for the 2019-on Isuzu D-MAX swaps out the stock bumper for a full steel front end that actually cops the hits. You get rated recovery points built in so you can pull the ute out of clay ruts or soft sand without hunting for a tow hook. Dual antenna tabs make it simple to run UHF and GPS gear when you get out there on long corrugated tracks.

The bar comes winch compatible so you can bolt in a standard low-mount winch and sort self-recovery before the next trip. Hi-lift jack points are cut into the face so lifting a wheel is straightforward when you are dealing with rocks or washouts. A matte black powder-coated finish handles chips and grime better than bare metal in Aussie conditions. For a D-MAX running touring gear this front bar is a smart buy.

• Full bumper replacement AFN bullbar
• Suits Isuzu D-MAX 2019 to current
• Integrated rated recovery points for pulls
• Winch compatible centre mounting section
• Dual antenna tabs for communication gear
• Hi-lift jack points on bar face
• Matte black powder-coated steel finish
• Provides improved front-end protection
• Supports common touring and work setups
• Branded AFN 4x4 Australia gear

Q: Does this AFN bullbar work with factory winches or only aftermarket units?

The AFN bullbar is described as winch compatible, which means it is intended to accept a compatible winch. You can match an electric winch with a standard low-mount pattern to the bar. Check the winch dimensions and mounting pattern against the bar before purchase. If you are unsure, our crew can help you pick a winch that suits this setup.

Q: Are recovery points included with the bar or sold separately?

Rated recovery points are included as part of the bullbar assembly. These points are built into the bar so you have a solid hook-up location for snatch straps and winch lines. Use rated bow shackles or soft shackles that match or exceed the recovery point rating. Always follow safe recovery practices and use appropriate rated gear.

Q: Can I mount more than one antenna on the bar?

Yes, the bullbar includes dual antenna tabs. This lets you run two separate antennas such as UHF and a second UHF or GPS unit. The tabs are located on the bar so cables can be routed neatly back to the cab. Choose antennas that suit your touring or work needs and mount them using the supplied hardware from the antenna brand.

Q: Does the matte black powder coat need special maintenance?

The matte black powder coat does not need special products, just basic cleaning and care. Rinse off mud and salt after beach or outback trips. Wash with mild car shampoo and a soft sponge to avoid scratching the finish. Inspect for any deep chips and touch them up to protect the steel underneath over the long term.

Suits Isuzu D-MAX model years 2019 to current. Bullbar configuration is a full bumper replacement style. Front bar includes rated recovery points and winch compatible mounting. Bar incorporates dual antenna tabs and hi-lift jack points to support touring setups.