This Camec 1 Hi-Rise 50mm Chrome Tow Ball steps your 50mm coupling up by about 25.4mm so the drawbar sits higher off the deck. That extra clearance helps when you drag a 2000kg box trailer up steep driveways or across spoon drains. A 22.23mm shank suits 7/8" tongues, so you can swap out your standard ball and keep the same hitch setup.

The steel body with chrome plating handles long runs on hot bitumen and dusty tracks without chewing out the 50mm coupling face. Shank length of around 51–52mm gives enough thread to clamp firmly on most tongue plates without leaving a heap hanging out. Rated to 2000kg, it matches light camper trailers and general-duty rigs that stay inside the 2 ton mark. Grab it as a smart buy when you need that bit more height at the hitch.

• Hi-rise 50mm chrome plated tow ball
• Raises coupling height by approximately 25.4mm
• Rated towing capacity of 2000kg (2 ton)
• Tow ball diameter suits standard 50mm couplings
• 22.23mm (7/8") shank diameter for common tongues
• Shank length approximately 51–52mm for standard plates
• Solid steel construction with chrome plated finish
• Supplied with securing nut on threaded shank
• Suitable for light trailers and small campers within 2000kg rating
• Camec TB50HR1 tow ball for general towing setups

Q: What size towbar tongue hole does this tow ball suit?

It suits towbar tongues with a 7/8" (22.23mm) hole. The shank is machined to 22.23mm so it matches standard 7/8" rated tongues without slack. Always check the hole size stamped on your towbar tongue before fitting. If the hole is larger or smaller, use a correctly matched tow ball instead.

Q: What is the maximum towing capacity of this hi-rise tow ball?

The maximum rated towing capacity is 2000kg. This means your trailer's ATM and towbar rating must both be 2000kg or less to stay within spec. The 2 ton rating makes it suitable for many box trailers and smaller campers. Never exceed the lowest rating in your full towing setup.

Q: Will this tow ball work with a standard 50mm trailer coupling?

Yes, it is a standard 50mm tow ball. Any trailer coupling marked 50mm and rated to 2000kg or above will physically fit this ball. Always confirm the coupling is in good condition and matches the rating of your towbar and tongue. Replace worn couplings before use.

Q: Why would I choose a hi-rise tow ball over a standard one?

A hi-rise tow ball raises the coupling height to help with ground clearance. That extra height can reduce scraping of safety chains, jockey wheels and plugs on steep driveways. It can also help level some trailers without changing suspension or tyre size. Always make sure the new height still keeps the trailer sitting level when loaded.